Aftermarket rails with stock lines
#1
TECH Enthusiast
Thread Starter
Join Date: Jun 2006
Location: Enid, OK
Posts: 594
Likes: 0
Received 0 Likes
on
0 Posts
Aftermarket rails with stock lines
Iv been looking for new fuel rails and found alot. Im using the stock feed and return lines right now. I saw the PP kit and was gonna get that but its only 3/8 dia and this motor is gonna need some fuel. Now I know theres other kits but I take it im gonna need to fab up and crossover and fittings to adapt to the quick connects the stock system has? Also I need to run a fuel line to a nitrous noid so ill need a fitting for that as well.
Last edited by BigDB; 01-10-2009 at 06:57 PM.
#2
TECH Addict
iTrader: (11)
If you haven't done a lot of plumbing I would advise going with a kit. I would contact NastyN8, Rev Xtreme or Lonnies Performance, all have nice kits and know fuel systems.
There are so many methods and so many AN hose/fitting vendors that the options are almost limitless.
There are so many methods and so many AN hose/fitting vendors that the options are almost limitless.