Will this setup crack 450 rwhp?
01-19-2009, 07:51 AM
#1
TECH Resident
Thread Starter
Join Date: Feb 2002
Location: Roseville, Ca.
Posts: 843
Likes: 0
Received 0 Likes
on
0 Posts
Will this setup crack 450 rwhp? I realize this is just another gay thread, but bear with me.
Please no comments on which heads I "should have" bought.
This is what I have and am stuck with for awhile... need your opinions.
What ballpark numbers do you think this thing will put down with a 347, Fast 90/90, very nicely ported 241's with 2.02's milled to 10.5 to 1 cr, torquer V2, EWP, underdrive pulley, longtubes, cutout, M6 through a 12 bolt with 373's and a good tune? The new motor is almost done. I'll buy the closest guess a beer.
I'm gonna guess 430-440. Am I on track or do you think it can make more?
Please no comments on which heads I "should have" bought.
This is what I have and am stuck with for awhile... need your opinions.
What ballpark numbers do you think this thing will put down with a 347, Fast 90/90, very nicely ported 241's with 2.02's milled to 10.5 to 1 cr, torquer V2, EWP, underdrive pulley, longtubes, cutout, M6 through a 12 bolt with 373's and a good tune? The new motor is almost done. I'll buy the closest guess a beer.
I'm gonna guess 430-440. Am I on track or do you think it can make more?
01-19-2009, 09:22 AM
#2
11 Second Club
iTrader: (34)
Join Date: Feb 2005
Location: Ft. Wayne, Indiana
Posts: 3,158
Likes: 0
Received 0 Likes
on
0 Posts
I realize this is just another gay thread, but bear with me.
Please no comments on which heads I "should have" bought.
This is what I have and am stuck with for awhile... need your opinions.
What ballpark numbers do you think this thing will put down with a 347, Fast 90/90, very nicely ported 241's with 2.02's milled to 10.5 to 1 cr, torquer V2, EWP, underdrive pulley, longtubes, cutout, M6 through a 12 bolt with 373's and a good tune? The new motor is almost done. I'll buy the closest guess a beer.
I'm gonna guess 430-440. Am I on track or do you think it can make more?
Please no comments on which heads I "should have" bought.
This is what I have and am stuck with for awhile... need your opinions.
What ballpark numbers do you think this thing will put down with a 347, Fast 90/90, very nicely ported 241's with 2.02's milled to 10.5 to 1 cr, torquer V2, EWP, underdrive pulley, longtubes, cutout, M6 through a 12 bolt with 373's and a good tune? The new motor is almost done. I'll buy the closest guess a beer.
I'm gonna guess 430-440. Am I on track or do you think it can make more?
I'm gonna be more on the conservative side and say 390-400.
