Ironxcross

iTrader: (8)

I just wanted to share this gauge holder I made. Overall, the design is really simple, and works great. I added the leather covering just so it would match the shifter boot along with the seats.

Here are some pictures, pardon the slight mess:






that black wire goes to my gps, disregard that

and to those thinking about getting an aeroforce interceptor gauge, its a great investment if you like monitoring the usual car functions in a more casual manner.

3800RS

iTrader: (15)

i did the same thing but i got my vinyl a little bit tighter. You should use a hair dryer to stretch it

Ironxcross

iTrader: (8)

I was going for a looser look, similar to the shifter boot.

6LITEREATER

iTrader: (56)

If you get bored with the vinyl I'll give you one of these for $20 shipped...



...$10 discount just to help you out if you want it. It is 1/4" ABS and really solid.

Magnet

iTrader: (36)

i know you said you were going for a loose look, but it makes it look kinda cheap in my opinion.. I would tighten it up for a cleaner look...

Danny2tek

iTrader: (1)

Exactly what I was thinking

99345hp

yeah, tighten up that vinyl. It looks horrible that way. I know the look you were going for, but the look doesn't work IMO.

litemup02

iTrader: (39)

^^X2 or just take 6litereater up on his offer

94'BLKBRD

iTrader: (76)

looks like poop

firehawk#682

iTrader: (19)

ooo you need to tighten up the leather but if you like it then go with it.

The Postman

iTrader: (44)

yea it needs to be tight on there...looks like you just half assed it IMO...

FamousZ

iTrader: (4)

Like everyone else has said, it really needs to be tight leather.. With it being all loose makes it look like you didnt put too much time into it and makes it look like its cheap and out of place...