Searching for UD pulley installers in the El Paso, TX!
#1
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Feb 2005
Location: Kyle, TX
Posts: 525
Likes: 0
Received 0 Likes
on
0 Posts
Searching for UD pulley installers in the El Paso, TX!
I was wondering if anybody could tell me if there is anybody in the El Paso, TX area that would install my UD Pulley for me and how much would it cost me. It's going on my 1998 Camaro Z28.
#3
TECH Addict
iTrader: (3)
Join Date: Apr 2005
Location: Dallas, TX / Boston, MA
Posts: 2,169
Likes: 0
Received 1 Like
on
1 Post
+1 for do it yourself... or bribe a fellow LS1Tech member with beer. FYI: you need a torque wrench that can go up to 250ft-lbs.
if you are going to do it yourself, make sure you get the car as high in the air as possible. you need lots of room to move to get the leverage to get that 250ft-lbs!
if you are going to do it yourself, make sure you get the car as high in the air as possible. you need lots of room to move to get the leverage to get that 250ft-lbs!