Nearly Done
Trending Topics
02-13-2009, 07:26 AM
#12
TECH Apprentice
iTrader: (2)
Join Date: Aug 2006
Location: OKC, OK & Hatteras Island, NC
Posts: 310
Likes: 0
Received 0 Likes
on
0 Posts
Looks like you did it to give you more ground clearance on the cross over pipe. I am in the same boat. I would love to lower it, but my exhaust is so low. I would have to get a new k-member, and then redo the exhaust. Not out of the question, but It is going to have to wait for now.
Your car looks good.
Your car looks good.
02-17-2009, 09:01 PM
#17
On The Tree
iTrader: (1)
Join Date: Jun 2006
Location: Gilbert, AZ
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
Car is looking good. Has it been driven at all since the springs were installed? If not, the car will need to settle after a few hundred miles. It's amazing how much springs will settle after a few miles.
02-18-2009, 10:10 AM
#18
TECH Enthusiast
Thread Starter
iTrader: (12)
Join Date: Oct 2008
Posts: 701
Likes: 0
Received 0 Likes
on
0 Posts
Well that is good news. I would be happy if it dropped just a little bit more. I did like the old drop but it was just too much of a pain in the ***. Just taking a drive on around pot holes became hazards. As you can see in the pictures there was not a hole lot i could do with the cross pipe sitting so low.
