LS1TECH - Camaro and Firebird Forum Discussion

Generation IV Internal Engine 2005-2014 LS2 | LS3 | LS7 | L92 | LS9

Question about 317s

Thread Tools
 
Search this Thread
 
Old 02-19-2009, 05:11 PM
  #1  
TECH Fanatic
Thread Starter
iTrader: (25)
 
95FbFormula's Avatar
 
Join Date: May 2006
Location: Canton, OH
Posts: 1,148
Likes: 0
Received 0 Likes on 0 Posts

Default Question about 317s
Did not find this in search how far can I mill 317s
95FbFormula is offline  
Reply Like
Old 02-19-2009, 10:44 PM
  #2  
Banned
iTrader: (3)
 
Richard@WCCH's Avatar
 
Join Date: May 2002
Location: Van Nuys, CA
Posts: 1,853
Likes: 0
Received 5 Likes on 5 Posts

Default
We try to limit flat milling to .045". This allows the intake to bolt up and it leaves enough to mill in the event the heads need surfacing in the future. What size chambers do you need?

Richard
Richard@WCCH is offline  
Reply Like
Old 02-20-2009, 07:52 PM
  #3  
TECH Fanatic
Thread Starter
iTrader: (25)
 
95FbFormula's Avatar
 
Join Date: May 2006
Location: Canton, OH
Posts: 1,148
Likes: 0
Received 0 Likes on 0 Posts

Default
Well I am just looking to get them down so I can bump the SCR and run a bigger cam something along the line of 236-242 .650s and 111 to 113 LSA I will also be using a .040 gasket.
95FbFormula is offline  
Reply Like
Back to Subforum
Generation IV Internal Engine
View Next Unread
good deal?




Advanced Search

All times are GMT -5. The time now is 07:21 AM.