What are you guys doing with old wiring?
#1
TECH Fanatic
Thread Starter
iTrader: (12)
Join Date: Aug 2007
Location: Cornfields near Pontiac, IL
Posts: 1,818
Likes: 0
Received 1 Like
on
1 Post
What are you guys doing with old wiring?
I dont want to pull the whole wiring harness, but I have a bunch of wires that used to go to stuff like the a/c, cruise control, foglights, etc. Are you guys just snipping these and taping them up? Just trying to figure out the safest and cleanest looking way short of pulling the harness out.
#3
TECH Fanatic
Thread Starter
iTrader: (12)
Join Date: Aug 2007
Location: Cornfields near Pontiac, IL
Posts: 1,818
Likes: 0
Received 1 Like
on
1 Post
If i cut them, do I just wrap the ends with electrical tape or what is everyone doing? Trying to clean up the engine bay now that half this stuff is gone.
#4
TECH Junkie
iTrader: (71)
Join Date: Mar 2002
Location: East Brady, Pa
Posts: 3,703
Likes: 0
Received 0 Likes
on
0 Posts
At first I just pulled them back as far as I could and taped them up. When I had my motor out I traced them back and snipped them. They all terminate some place so there wasn't really a need to retape them after they're cut.