TDPB2008

iTrader: (2)

lookin to buy thoq thrust m 17x10.5 and 315s in the rear am i going to have any problems fittin these in the rear?

onyx_rock

iTrader: (8)

no, i had them

mondols1

iTrader: (2)

no probs

airforcemanss

iTrader: (23)

i plan on doing this in the future. i heard the nittos are not problem but what about mickey's out back that run a bigger 315? would it be better to run et streets with 295's out back an have some more side wall? or are the mt 315's fine on the 10.5?

BassProCamaro97

iTrader: (10)

I have 11 inch TTII's in back with Hoosier 315's (Hoosier is supposed to be a larger tire)

I had to remove the bump stops but they fits nicley back there.

~Jim~

MrElectric03

iTrader: (71)

None at all if you arent lowered, when I was on Eibachs i had to "roll" the inner quarters, other than that nothing.

'02 WS6

iTrader: (73)

I'm on 315's w/ 10.5 TTMS, and lowered on Stranos...no BFH, bump stop removal, or fender rolling needed. Nice snug fit.

946spdz

iTrader: (19)

what tire do u have 02 ws6?

Ryan S.

I'm thinking of running the 10.5s in the back on my 96 TA. Do you have any pictures of this setup on your car?? what are you running in the front for width.

I have been looking for information on the size of the lip on these wheels. Some pictures I see have a large deep dish look while others don't. I want to run a staggered look with deeper dish in the rear. I am currently thinking 17x9 in front and 17x10.5 in the rear. Can anyone provide more info about this?

Thanks in advance

02BLKWS6MD

iTrader: (22)

I did the BFH mod just so they dont happen to rub in a hard turn. I didnt roll my quarters either but I'm using the eibach pro-kit. I'm running 315 BFG drag radials but want to move up to mickey thompsons next.

'02 WS6

iTrader: (73)

I was on Sumi's but now on Nitto 555r and still no rubbing.