possible sticky, E-cutout wiring
04-07-2009, 02:17 AM
#1
TECH Fanatic
Thread Starter
iTrader: (12)
Join Date: May 2005
Location: Nashville, TN
Posts: 1,250
Likes: 0
Received 0 Likes
on
0 Posts
possible sticky, E-cutout wiring I noticed a lot of people asking about wiring their e-cutouts, for whatever reason, maybe they didnt recieve the pre-wired switch with their purchase.
I made a drawing in PS that may help
you need a 6 pole toggle switch. You have to wire it to where it reverses the polarity to go from open to close on the cutout, i.e. you want wire "A" to have 12v positive power to open the cutout, and you want it to be 12v negative to ground to close the cutout. Same goes for the other wire.
Hope this helps
-James
I made a drawing in PS that may help
you need a 6 pole toggle switch. You have to wire it to where it reverses the polarity to go from open to close on the cutout, i.e. you want wire "A" to have 12v positive power to open the cutout, and you want it to be 12v negative to ground to close the cutout. Same goes for the other wire.
Hope this helps
-James
