Accessing fuse panel expansion connections
#1
Staging Lane
Thread Starter
Join Date: Apr 2006
Location: Troy, MI
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Accessing fuse panel expansion connections
I decided for installing my cb radio and my fuel and nitrous pressure gauges that I would use the ACCY and IGN spare expansion connections on the fuse block, but after a whole lot of time taking off things trying to get wiggle room, I cannot figure out how to get access to the back of the panel. Is this a PITA for everyone or am I missing something simple. Can somebody please let me know how to get to those, I really don't want the car to beat me on this one.
#2
Staging Lane
Thread Starter
Join Date: Apr 2006
Location: Troy, MI
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
I have seen post from people saying to use these so somebody has got to have have advice about it, I need to get the car back together today so somebody please chime in.
#3
TECH Senior Member
iTrader: (7)
you can just slide in a 0.25 male disconnect into these locations? I know I did that in the past, but now all of my power taps are off of the radio harness, since I have an aftermarket radio anyway, I have a power, ground, switched, and dash illumination coming off of the radio harness, without cutting any factory wires. (I hate hacking up factory harnesses)
Ryan
Ryan