Gears & Axles - 2 Questions after 9" install



PDA

View Full Version : 2 Questions after 9" install

RHYNO6.0
04-30-2009, 07:27 PM
Does anyone have a link for bleeding brakes? I bleed them but they still aren't 100%


There is a noise coming from the pinion maybe or that general area and I have no idea what it is. Kind of a squeak with each rotation. Has anyone had this problem and also how tho you set the pinion angle without that tool from BMR? Adjusting the torque arm quites the noise a little it but it never stops fully.

SILVER SS 00
04-30-2009, 07:59 PM
got a question for you. did you put it together,if so how far did you press on the bearings
EPP
04-30-2009, 08:57 PM
Does anyone have a link for bleeding brakes? I bleed them but they still aren't 100%


There is a noise coming from the pinion maybe or that general area and I have no idea what it is. Kind of a squeak with each rotation. Has anyone had this problem and also how tho you set the pinion angle without that tool from BMR? Adjusting the torque arm quites the noise a little it but it never stops fully.

http://www.popularmechanics.com/automotive/how_to/4213448.html
Link to bleeding brakes.

Pick up an angle finder from your local hardware store ($4.99 at Sears) to adjust the pinion angle. You could have a u joint that is squeaking, which can happen if a needle bearing is out of place or if one of the caps was tightened down too tight. Bob