Vicinity

iTrader: (7)

How do I get it off, I'm about to hack saw it because it's pissing me off.

Any suggestions before I tear this **** apart?

blownws6_nc

iTrader: (10)

use a hair dryer to heat the plastic up and it should slip off. be patient.

Sommer86

iTrader: (46)

yeah, just put your moms blow drier on it, on hot, for a couple of minutes...the plastic will expand and come off easier. That's how you get it back into the SLP lid too.

Vicinity

iTrader: (7)

Wow, that worked. Thanks a lot, man.

Vicinity

iTrader: (7)

I'm not allowed to have a hair drier?! Lol. And thanks yeah, needed to do it to get it on the SLP lid too.

ScrapinBye

I just put my lid (the neck) in boiling water 4 a minute or so and it slipped EASILY back on to the MAF.

LS1BLKSS

iTrader: (36)

how did you do that without getting the MAF wet???

ScrapinBye

I used a hairdryer to get it OFF the MAF. Of course when it was time to put the damn thing back together, the plastic neck had cooled and shrunk to its normal size. Then I put the neck in boiling water to get it BACK ON the MAF.

Quick99Si

iTrader: (27)

HOW TO SEPARATE LID AND MAF

Required:
(1) Friend w/ two functioning arms
(1) Can of WD-40

Steps:
(Gonna need a few days for the full write-up )

JosephIV

iTrader: (14)

The better question for the TS is: How do you have 1,400 posts and still have the stock lid?

Just giving you crap. The Berger panel looks good on your car. You NEED rims though.