Help
#1
TECH Apprentice
Thread Starter
iTrader: (4)
Join Date: Mar 2007
Location: north dallas
Posts: 390
Likes: 0
Received 0 Likes
on
0 Posts
Help
A while back i hit a curb and fucked up my rear axle alignment. I just installed a tubuler sin adj pan hard bar and while installing the panhard brace looked bent but i couldent tell if that was how it already was,also installed single adj lower control arms,lca relocation brackets, and shocks and springs. Can anybody give me some direction on how to get it back to normal? the torque arm also looks bent. Would that be the most of my problem? the axle is sticking out about .5 inch to the driverside
Last edited by gc302047; 05-16-2009 at 12:46 PM.