1CAMWNDR

iTrader: (21)

The Victor Jr. has a place for a fitting on the #8 runner, but the Super Victor does not. How do you set that up on the Super Victor??

1CAMWNDR

iTrader: (21)

I guess pick a runner and drill and tap it??

TJ

iTrader: (10)

yip.
i did mine in the rear on the #7 cylinder. just put the drill in there at an angle thats easy to get to and go at it.
what i had to do.

1CAMWNDR

iTrader: (21)

I decided to go with a Victor Jr. I will have an easier time fitting Jr. under the flat VFN hood.

TJ

iTrader: (10)

how much power are you making?
i see you are in nw florida. close to pensacola?
the super victor may benefit if you are over 400 inches or spinning 7000+
word to the wise, edelbrock states its 1.12 inches taller than a vic jr. THIS IS FALSE.
measuring one to the other from the valley pan to the carb flange was 1 9/16 taller.

1CAMWNDR

iTrader: (21)

I am over in Chattahoochee. I may be a few hp down compared to a Super Victor with the Jr and a 4BBL throttle body, but I will be a bunch OVER what I would have been with the BBK and 85mm throttle body.