rwb

Any ideas why my car would be eating map sensors?? It is procharged but only sees 8.5 lbs of boost. If I put a new map sensor in it, it will run for about 10 minutes then it tells me high current on map sensor and dies. The measured voltage is always 12 to 13 volts so I am out of ideas. I have measured the wires with a vom and all was good. Anybody with any ideas??

CamaroSS19

iTrader: (24)

Im not 100% but pretty sure it should be reading 5v you may have a bad cpu

rwb

It has 12v in and 5v out to the computer.

hellbents10

iTrader: (10)

Should only have 5v in and then 0-5 for signal back to the computer. You either have a short to batt or a bad computer.

rwb

I went and remeasured it and it is 5v in. Sorry my bad.