Walbro pump installation problem
07-11-2009, 05:37 PM
#1
Walbro pump installation problem I installed the pump per the directions but car will not crank. Pulled the pump back out and there was plenty of fuel in the bucket. But it seems like there was no fuel going to the lines. Any ideas?
07-13-2009, 09:07 AM
#3
Once again I got it fixed 
...
The manual that came with the pump had the polarity reversed.... I looked around online and found a schematic and got my ohm meter out and sure enough it was.... Switched wires around and she runs fine
... The manual that came with the pump had the polarity reversed.... I looked around online and found a schematic and got my ohm meter out and sure enough it was.... Switched wires around and she runs fine
