Machining costs
#1
Teching In
Thread Starter
Join Date: Sep 2008
Location: Virginia Beach, VA
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Machining costs
I'm getting a 350 block from a buddy of mine (for free no less!). He said he had it magnafluxed and pressure tested and it was good, but it needs a cylinder sleeved. How much should this cost on average?
#3
TECH Enthusiast
iTrader: (1)
Join Date: Sep 2005
Location: Gap, PA
Posts: 604
Likes: 0
Received 0 Likes
on
0 Posts
i would say at least 300 bucks. i have bored and installed alot of sleeves. time consuming. You have to bore the cylinder out for the sleeve, install the sleeve, possibly have to bore the sleeve and then hone it.