Bearings in Procharger Headunit?
07-25-2009, 11:37 AM
#1
Bearings in Procharger Headunit? Mr. Big has sparked my interest on a subject, so I was wanting to know how many of you have had a P1, D1, F series blowers apart and what bearings were used in them? I have heard rumors that ABEC 1 bearing have been used in P1/D1 models.
Plus I read an article that stated
"According to ATIs Dan Jones, most centrifugal blowers are tripling the speed rating of their bearings, while working well under the intended load rating. This environment requires strict attention to lubrication."
Found out the ABEC 1 is rated around 25,000 rpms (Grease lubrication) and another 6,000 rpms with oil lubrication.
Anyone have any info or opinions?
Plus I read an article that stated
"According to ATIs Dan Jones, most centrifugal blowers are tripling the speed rating of their bearings, while working well under the intended load rating. This environment requires strict attention to lubrication."
Found out the ABEC 1 is rated around 25,000 rpms (Grease lubrication) and another 6,000 rpms with oil lubrication.
Anyone have any info or opinions?
