MasterMindMotorsport

anyone tried using the hooker block huggers yet ? Im doing an LQ9 on my personal car and just remembered about these from use on a 34 ford LS2 swap I did. Only thing I would think to not work out is the steering ?


any input appreciated

bjamick

iTrader: (31)

I'm not for sure, they should work. I wish you could get measurements off of a site so you can make a decision and not waste your money.

jfg455

iTrader: (5)

No they wont work on the drivers side due to steering clearance. Look down in this build and you will see a good shot of the drivers side block header and how it covers the motor mount. In the 99 stang I did the steering arm goes right under the drivers side motor mount.

https://ls1tech.com/forums/conversio...old-volvo.html