Katech_Jason

iTrader: (19)

I have a lot of head studs here that were never made into a kit. They are for the early LS1 long/short style heads. They are made in the USA by A1 Technologies, a Motorsports and Aerospace fastener manufacturer so they are top quality. They are black oxided. The only catch is they are BYONW - Buy Your Own Nuts & Washers. They don't come with it so you would have to source them from ARP or elsewhere. Is that a good deal for $100? Would anybody be interested?

00cls1camaross

iTrader: (10)

It would depend on the extra cost from arp.

Any word on what all the extras would cost?

Katech_Jason

iTrader: (19)

I found two of the four part numbers so far that it will need. Using those two to estimate the other two I figure about $70.

koolrayz

iTrader: (26)

I thought the A1 was superior to the ARP. Do you normaly stock A1?
What would the torque specs be?

Beaflag VonRathburg

iTrader: (176)

^ Depends on the material they are made of.

hirdlej

iTrader: (31)

Not if I can't get them for an '04+ block

01ssreda4

iTrader: (96)

Hate to bump such an old thread but did anything ever come of this?

Katech_Jason

iTrader: (19)

Nothing did. There was very little interest.

bmeyer40

iTrader: (5)

I know this is old. But is it still possible?

Katech_Jason

iTrader: (19)

Wow this IS old. We still have the studs I think. There wasn't much interest in this.

bmeyer40

iTrader: (5)

Haha I know. The 2 bolt ebay studs are on national back order. I am interested. The A1 studs are of ARP quality arent they?

Werewolf SS

iTrader: (3)

The 2 bolt ebay studs were removed from Procomps Catalog. I'm not sure there is any plans to make more and since they pulled it from their own store as well as the the 2014 catalog listing. I have doubts.

bmeyer40

iTrader: (5)

Even better KaTech please make us a good stud set for less than ARP!