fuzzyjk

iTrader: (4)

Bought a brand new stock LT1 block for my 94 Z28. I was planning to swap the following parts (already purchased) 1.6rr, 227 Crane cam, LE1 heads, LT headers and 3600 stall.

I now have the chance to buy a used 4.5lbs Powerdyne supercharger for $1000.00 with the 6lbs pulley included.

Question.....will putting these mods in help of hurt the boost. I have read a lot about flow and overlap and still do not understand it. Most of what I read says stock cam is the best choice. Its that still true with such a small cam, stock short block and low boost?

Thanx for the help.

SilverSS

iTrader: (30)

what are the cam specs? i've seen a stock cammed stock cube lt1 run bottom 10's with a blower. stock cam is good but not the best.

stevied916

iTrader: (30)

if it's the 210-224 on 112 then it will be ok. You would be better off with 114 or higher but there is still negative overlap so it will be fine.

fuzzyjk

iTrader: (4)

The cam is 210/224 .511/.553 114 LSA.

With the mods stated above and the powerdyne will I be in the 500 hp club (crank)?