Anyone had this happen??
#2
Launching!
iTrader: (1)
Join Date: Feb 2009
Location: Lafayette, LA
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
Interesting, looks like there wasn.t much holding it. Take it you haven't been in a accident to stress the floor since installing the crossmember?
After looking closer, looks like either poor penetration but the weld actually look to have split.
After looking closer, looks like either poor penetration but the weld actually look to have split.
#4
12 Second Club
iTrader: (4)
Join Date: Jan 2005
Location: Texas
Posts: 1,200
Likes: 0
Received 0 Likes
on
0 Posts
That looks like to be a first. maybe it scraped too many times and stressed it out-Have you contacted the maker? Yea after another look that isnt from bottoming out. not to much damage to the underside.
Last edited by tillery; 11-02-2009 at 09:59 PM. Reason: Studying picture.
#6
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Location: South Carolina
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
Lol...here is the story and its nothing extravagant....it got hung going into a car wash bay....after getting it out of the bay I couldn't see any damage, but as soon as i started driving i could tell, mainly because the safety loop was barely touching the drive shaft...I had a friend weld it up for me..but shoulda contacted the manufacturer and sent it back if possible...because as you can see it wasn't welded very good the first time...