GTP 4" cutout is falling apart...
#1
GTP 4" cutout is falling apart...
Ok so I've got this 4" QTP cutout. So far I have had the metal bar that the "flap" is connected to, break in half, the bolts have fallen out, and now the new rod I had made to fit in there isnt staying in place. I'm at whits end on what to do with this pile of ****. Can I send it in and have it rebuilt? Or maybe buy a new rod and some bolts or somthing? Anyone else have any experiences like this? I always heard the motors on these things were bad about going out...well my motor hasnt gave me any problems, just the damn hardware.
On a side note, does anyone know if a higher quality (DMH I think?) would bolt up to the flange of the QTP?
On a side note, does anyone know if a higher quality (DMH I think?) would bolt up to the flange of the QTP?