kobraa

iTrader: (1)

I bought a new hydraulic throwout bearing line but I'm havin trouble installing it. I posted pictures of the connection...anybody know the easiest way of removing and installing a new line?

Spartan7

iTrader: (7)

You're probably going to have to remove the master to do it. Just use a punch to get the roll pin out and the line pops right out of the MC.

PewterScreaminMach

iTrader: (7)

x2 on pulling the master. I've never seen anyone replace the line without removing the master. Although, I guess it's "technically" possible, just not too realistic.

gearhead1186

iTrader: (8)

looks like its gotta come out.. it aint worth the frustration trying to get at it..

screaminChick-n

[QUOTE=kobraa;12559096]I bought a new hydraulic throwout bearing line but I'm havin trouble installing it. I posted pictures of the connection...anybody know the easiest way of removing and installing a new line?Attachment 207235

Attachment 207236[/QUOT]

If you dont mind where did u buy it from part #

Thanks

kobraa

iTrader: (1)

I got it from Summit...part number is MCL-139212

dschmittie1

iTrader: (64)

I don't think it is that hard to remove the line in the car. I have swapped 2 lines without removing the MC. I have a long radiator hose pick that I use to pop the roll pin out. I guess it would be hard if I didn't have this.