custom nitrous piston, check it out.
#1
10 Second Club
Thread Starter
custom nitrous piston, check it out.
these are good for a 400+ shot according to Diamond. congrats to them on there service and quality. these only took 2 weeks to finish when i was told a month so i was suprised. the rods are good for 1000HP at 7500RPM according to Scat. cant say to much about there service but the quality is very nice.
Trending Topics
#10
10 Second Club
Thread Starter
the pistons cost around $700 though Diamond and the rods were only $450, but after selling some parts i had and my $100 gift certificate from Diamond i didn't pay a thing. those are the deals i like.
vents, i have the same question about the cable. we both have money in it so holfully it can get fixed. i will really need it when i put this motor together.
bigmike, these are custom pistons since the stroke is odd and the ring land is lowered for more spray so no part number. they are also for 1/16, 1/16, 3/16 ring pac so i can just use regular off the shelf SBC rings.
vents, i have the same question about the cable. we both have money in it so holfully it can get fixed. i will really need it when i put this motor together.
bigmike, these are custom pistons since the stroke is odd and the ring land is lowered for more spray so no part number. they are also for 1/16, 1/16, 3/16 ring pac so i can just use regular off the shelf SBC rings.
#14
10 Second Club
Thread Starter
vents, that sux. when it gets back, i can go over to your house and tune it for ya. i am going to have similar problems when this motor is intalled. i was upset when it broke because i could not tune danials car. what compression ratio are you running. last time we tried tunning it, it was running around 930 on the O2s. what have you changed since then?
#17
10 Second Club
Thread Starter
Originally Posted by BADZ
Must be nice, I paid 1000.00 for my Oliver rods and 885.00 for my JE Custom Racing Nitrous pistons, they were custom cut though...