HSW Microedge installed......RPM's are off??
#1
HSW Microedge installed......RPM's are off??
I just got my Microedge to work and when I started the car, the RPM's on the microedge read around 4000rpms. Thats when my car is idling. Now I hooked up the blue wire to the tach signal like it says. Is there something not configured (I also have Interface)?
I also bought there switch panel that goes in the change holder place and the light also doesnt light up when I flick the switch? I tested the 12v and the ground and both work. Also the green wire from the microedge to the switch is also hooked up. Dont know why it doesnt light up?
I also bought there switch panel that goes in the change holder place and the light also doesnt light up when I flick the switch? I tested the 12v and the ground and both work. Also the green wire from the microedge to the switch is also hooked up. Dont know why it doesnt light up?
#7
FormerVendor
iTrader: (4)
Join Date: Jul 2005
Location: Glenolden, PA
Posts: 1,954
Likes: 0
Received 0 Likes
on
0 Posts
Nick