Anybody running a Moser M9, Or Midwset Chassis fab 9" with a Y-pipe? Pics please.
02-19-2010, 04:57 PM
#1
Teching In
Thread Starter
Join Date: Feb 2010
Location: michigan
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Anybody running a Moser M9, Or Midwset Chassis fab 9" with a Y-pipe? Pics please. I have a Moser M9 with torqe arm mounting to trans crossmember. Would like to run Y-pipe to Mufflex 4" over the axle. Worried about ground clearance, with torqe arm at lowest adjustment point. Wanted to see if anybody else, has run this set up? Or is it too much trouble, and should just go with true duals. Any pics would be helpful. Thanks.
