Convertible Vehicles - Some pics of my convertible. Needs a new top but still in good condition

Any suggestions? What to do next?

update... pic added with the top down..finally stopped raining

Next? Drop the top and take pics. Looks good as it is.

Its raining here but as soon as that stops, you got it.. Inside is stock except for the cluster and the TA door panels. Black leather

Any suggestions? What to do next?

I'd say change your exhaust pipes to something different. Not sure how to explain it, but I don't think those look right on that car, looks like something you would see on the back of a pickup or old mustang.

But my bias is, I don't like to see the exhaust at all, except on the birds where it needs to be there.

Lower it...Koni/Strano's..Corsa clone tips or 6LE's new rear valance ...Wheels & tires.

http://www.ls1.com/forums/showthread.php?t=132685

how about the center mount and not the ghetto one that slp made with quad tips but the real center mount. other then that lower it and call it a day car looks real good.

Looks good, another vote though on replacing the exhaust tips (at least with sometihng with dual/dual type of tips).

If you lower it, make sure you get appropriate rear springs for a vert or you could use the rear perch mod to lower rear end.

What's the rear perch mod?

Agreed that exhaust needs to go. If you have the coin, I have always loved the CME on your car and wished I could get it for my TA. Oh well ....

Very nice and I agree with the exhaust tips, however, I think they are just sticking out too far. My vote would be to move them in 3 inches and they would look fine..just my two cents worth.

I'll get another picture, they arent even outside of the bumper, just a bad angle pic

What's the rear perch mod?

You can lower the back of the car approximately 3/4" by removing the thick rear spring 'perch' (aka: isolator) and wrapping the end of the spring with a heater hose instead.

For the front you would just find a good 1" drop spring (I have hotchkis) and a set of good shocks all around.

Car looks nice, and would look better without tips!
Looks good, another vote though on replacing the exhaust tips (at least with sometihng with dual/dual type of tips).

If you lower it, make sure you get appropriate rear springs for a vert or you could use the rear perch mod to lower rear end.


So converibles have different springs:bang:? I have always thought they where the same. How bad would it be to run lt1 springs on the rear?
Sorry for the :hijack:

Car looks nice, and would look better without tips!



So converibles have different springs:bang:? I have always thought they where the same. How bad would it be to run lt1 springs on the rear?
Sorry for the :hijack:

Hmm, I hadn't heard they were any different, except that the car is a bit heavier. But then I am not a genius about these beasts....