C4 Ls1 Swap, wheelie picture
#1
Banned
Thread Starter
Join Date: Sep 2002
Location: So Cal, CA
Posts: 1,298
Likes: 0
Received 0 Likes
on
0 Posts
C4 Ls1 Swap, wheelie picture
I finally pulled a freeze frame from a video at the track...
This is leaving on a 250 shot....car pulled a 1.42 60 ft and went 110 mph in the 1/8th mile.... then the converter exploded...oh well..
The drivers side wheel was a good foot off the ground, passenger side about 6 inches...
still on the stock independant rearend Dana 44 with zero suspension mods, still have the factory shocks on it! 15x10 Weld Prostars /w 28x13.5 ET streets
Car should ran a 9.60-9.80 on this run but the tranny/converter didnt survive...
It was a forged 346, lpe cnc heads (flow 270), TR227/230 cam, ls6 intake, 3500 converter, 3.91 gears, mac headers etc.
https://ls1tech.com/forums/attachmen...achmentid=2091
This is leaving on a 250 shot....car pulled a 1.42 60 ft and went 110 mph in the 1/8th mile.... then the converter exploded...oh well..
The drivers side wheel was a good foot off the ground, passenger side about 6 inches...
still on the stock independant rearend Dana 44 with zero suspension mods, still have the factory shocks on it! 15x10 Weld Prostars /w 28x13.5 ET streets
Car should ran a 9.60-9.80 on this run but the tranny/converter didnt survive...
It was a forged 346, lpe cnc heads (flow 270), TR227/230 cam, ls6 intake, 3500 converter, 3.91 gears, mac headers etc.
https://ls1tech.com/forums/attachmen...achmentid=2091
Last edited by C4VetteLS1; 01-02-2004 at 04:03 PM.