StangEaterSS

iTrader: (41)

Just intstalled the hawk HPS pads on the camaro yesterday. was curious if there is any specific break in procedure on the first drive I should do.

FancyFarmSS

iTrader: (5)

If you go to the hawk website, choose performance street, and then choose the hps pad, you will see Bed-In/Burnishing instructions at the bottom of the page.

I will be installing new pads and rotors soon, and i'm sure i'll be following their instructions.

z_speedfreak

iTrader: (3)

there wasn't instructions in the box?

keith_AE2010

iTrader: (9)

The English instructions are on the bottom of the box if I remember right.

StangEaterSS

iTrader: (41)

There wasnt instructions IN the box, thats why I asked. I will have to look around in the garage for the box and check the sides and bottom of the box as KeithAE2010 suggested.

SS SLP2

iTrader: (8)

you may like to try this link
good luck, Johnny


http://www.essexparts.com/learning-center/Bed-in

Black02SLPSS

iTrader: (5)

The instructions arent IN the box they are ON the box. I dont remember exactly where, ill have to look at the ones i have in my garage

StangEaterSS

iTrader: (41)

they were on the side of the box. 6-10 moderate stops from 35mph. then a few stops from 45-50 mph with more pressure. then let them cool. that was the basic instructions

fccs

iTrader: (26)

Just do a 5minute burnout, that'll break them in..

-Don't actually do this lol

Black02SLPSS

iTrader: (5)

And thats all you will need to do. They will be great after that

NoTractionLS1

blahahahhahahah! Only if he really did this tho!