Question on clutch line fittings
03-25-2010, 07:27 AM
#1
Question on clutch line fittings Need a roll pin retained right angle fitting to -3 AN to fit on my Corvette C5 clutch master cylinder.
I found Russel fittings, but they are straight.
Failing that, do they make a Corvette C5 master cylinder port that comes out at a right angle like the F-bodies?
I found Russel fittings, but they are straight.
Failing that, do they make a Corvette C5 master cylinder port that comes out at a right angle like the F-bodies?
