G-FORCE Stg III C6 Z06!!!
#1
8 Sec Tuner
Thread Starter
iTrader: (2)
Join Date: Jan 2002
Location: Wish I was in a boat fishing...
Posts: 4,641
Likes: 0
Received 0 Likes
on
0 Posts
G-FORCE Stg III C6 Z06!!!
We just finished up a really nice C6 Z06. The power these cars make with simple mods is amazing! This car dives like stock until you go WOT then hold on! You can cruise any gear @ 1300 rpms with no surge!
2007 C6 Z06 Stg III
569 RWHP
506 RWTQ
http://www.youtube.com/watch?v=MaLuUyPfdtQ
2007 C6 Z06 Stg III
- LME Ported LS7 Intake (thanks Fellas)
- WCCH Stg 2 LS7 heads w upgraded exhaust valve
- G-Force Custom Cam Kit
- Morel Lifters and Comp Trunion Upgraded Rockers
- NGK Plugs & MSD Wires
- K&N FIPK
- Kooks 1 7/8 Headers and 3" Off Road X-Pipe
- Stock C6 Z06 Catback
- G-Force Custom Dyno Tune
- ACT Twin Disc Clutch
569 RWHP
506 RWTQ
http://www.youtube.com/watch?v=MaLuUyPfdtQ
Last edited by Mike TexaSS; 04-19-2010 at 02:21 PM.
Trending Topics
#18
8 Second Club
iTrader: (1)
Join Date: Nov 2001
Location: Friendswood
Posts: 10,121
Likes: 0
Received 0 Likes
on
0 Posts
Well if I didn't have a bad tank of gas I'd come over and smack around the yellow Z06 so he comes back for ANOTHER round of mods... But I still have yet to drive it to drain the gas out of it. Was to damn lazy to back out the truck and park it in the street this morning so i didn't drive it again!
Though I'm debating about doing a patio and outside kitchen before I build the motor... We'll have to wait and see how that goes!
Though I'm debating about doing a patio and outside kitchen before I build the motor... We'll have to wait and see how that goes!
#19
On The Tree
Join Date: Jan 2009
Location: Willis Texas
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
Well if I didn't have a bad tank of gas I'd come over and smack around the yellow Z06 so he comes back for ANOTHER round of mods... But I still have yet to drive it to drain the gas out of it. Was to damn lazy to back out the truck and park it in the street this morning so i didn't drive it again!
Though I'm debating about doing a patio and outside kitchen before I build the motor... We'll have to wait and see how that goes!
Though I'm debating about doing a patio and outside kitchen before I build the motor... We'll have to wait and see how that goes!
On another note if you go with the patio/kitchen make sure you have a build thread.