IH8FORD

iTrader: (6)

Removed the wiring and fuse box from the engine compartment and painted the engine comp. relocated my fuse box under the frame rail on the drivers side . I'm still in the process of soldering and heat shrinking my harness back together. I'll post pics this weekend of the finished product.






More pics



I have been rewiring my engine bay and getting ready to mount my coils on the back fire wall

Zmg00camaross

iTrader: (11)

Hmm i like, Please take more pics while in the process. It be worth it for all the room/ clean look.

DaynNight

iTrader: (5)

looks great did you have to get any longer lines?

IH8FORD

iTrader: (6)

What do you mean by lines. I had to extend the harness. I am changing my brake lines around too.

trans2000am

iTrader: (49)

looks good im in the process of doing the same thing that harness was a pain in the *** getting out with dash still in

00T/AWS6

iTrader: (17)

damn that loooks awesome. i've been contemplating doing something like this too. That thing got in my way during my sjm abs delete / LL install haha.

IH8FORD

iTrader: (6)

Thanks. I hated those fuse boxes there. I think GM could have done better.

trans2000am

iTrader: (49)

any updates?

IH8FORD

iTrader: (6)

I should have some more pics up by tomorrow. I have the next four days off work.

DaynNight

iTrader: (5)

my bad i was talking about the harness

FungusMungus05

iTrader: (1)

I am thinking about doing the same this summer. Looks very good!

IH8FORD

iTrader: (6)

Updated with more pics.

JonCR96Z

iTrader: (33)

You're gonna clean up that valley cover and change the crossover tubes before you bolt the intake back down, right? Looks much nicer without the plate.

IH8FORD

iTrader: (6)

I did that yesterday I'll send you a pic

3fingas

iTrader: (16)

Nice. Are you keeping the the bcm in the car?

Sharpe

iTrader: (7)

In for pics.

GhostofKrypton

iTrader: (7)

Would it have ben easier to run the Fuse boxes inside the car, and tuck them Behind the dash? Just curious as I would like to do this. I have already relocated the pcm inside the car and rerouted the wires on the passangers side, but hate the look of the fuse boxes on the drivers side. And my ATW intercooler will be sitting in the same spot you relocated your boxes to.

IH8FORD

iTrader: (6)

It wouldn't have been easier. But it can be done I cut the harness and extended it. You could cut it where I did and reconnect it with the fuse boxes inside. Then extend the wireing for your head lights turn signals. You would have to run your Main power wire from the alt/batt. inside the car though. It may be easier to find another place to mount the inter cooler.

IH8FORD

iTrader: (6)

Yes I am.