Justins00ss

iTrader: (18)

Well last saturday I got my 9 inch installed. I picked it up from a local member on here for a good deal.

Moser 9inch housing
Strange aluminum center section
Locker with 4.11s and 31 spline axles
LCA relocation brackets

And I also grabbed a Sphon chromoly driveshaft with the spicer u joints
sorry for the bad pics but you get the idea.

tylermurphy1

iTrader: (1)

how much was this beast?

Justins00ss

iTrader: (18)

Well I picked it up for 1600. Then the driveshaft was 250.00

killagt

iTrader: (3)

where u buy that licencse plate ?

Wicked94Z

iTrader: (26)

good luck with that aluminum center, i wouldn't run one in a 3000+ lbs car with power you have. unless it's an ultra case of course

Justins00ss

iTrader: (18)

Ya know, Ive had that for like 6yrs now. I was at a carshow back home in Mass one summer and there was a vendor there making them to order right on the spot. So for like 10 bucks I had him make it. Never saw that guy again, and never saw anyone else making them at a car show before. I always see them making plates but not the brackets.

qwk93ta

iTrader: (13)

Ditch that stock torque arm.....

Justins00ss

iTrader: (18)

Oh dont worry, thats next on the list. LOL

Camaro Junky

What do you think about the locker after some DD Justin?

Justins00ss

iTrader: (18)

This locker is dead quiet. I dont know if they re-designed them or what, but the only time I notice it is when I slow down and turn into my driveway it makes a little noise, other than that its dead quiet. Ive got caught in the rain after installing it and it drove fine.

One of my buddies told me that the reason some lockers unload is the one of the springs or something could be bad. I dont know too much about them but this one is very nice.