Advanced Engineering Tech - Any machineist in here?? I would appreciate the advice

I have a set of Eagle I beam rods with forged pistons I got in a trade deal. I would like to use the pistons for my 406 build but the rods are rated at 500 and I should make nearly 575hp on motor and gonna have a single plate kit as well.

Would like to go to a h beam rod but the I beam rods are press fit and the pistons aren't for floating rods either.

I was wondering if there are anyone who offer press fit h beam rods or if the set of pistons could be machined for a set of spiro locks and mill the wrist pins a little narrower??

I am not really worried about having bushed rods the motor should see peek power around 6500rpm.

Any help will be greatly appreciated.

what kind of pistons are they-i have yet to see a forrged piston that isn't already machined for pin locks

They have a part number of 7063p on them. I googled this number and found another person who was trying to figure them out as well but no success. Idk. They have a cnc finish to the heads of them with two valve reliefs. They look rather descent I guess they look better than a lot of speed pro piston's I have seen. But I have seen lower budget forged pistons advertised for press fit only.

What do you think?

I have a ROSS forged piston swingin' on a stock LS1 rod sitting in my garage that is set up for press fit pins.No provision for wire locks...

Yeah more often than not they have spiro locks but they do come without. Im just gonna buy rods and pistons. Its only money right? LOL.