DRTHVDR

iTrader: (6)

(I posted this in the automatic section to no avail)

I have a L92 from a 2007 Escalade and the starter came with the engine.
I am mating it to a 2000 Camaro T-56.

My question is: Does the starter work on this trans?

Do the 2007 L92 6L80 flywheels have a different amount of teeth as the 4th gen F-bodies flywheels?

jmd

iTrader: (4)

test fit the bellhousing & you'll have your answer.

No.

DRTHVDR

iTrader: (6)

I was going to install the trans this weekend.
Looks like I've found my answer.
So I need an F-body starter?

DRTHVDR

iTrader: (6)

I put the trans and engine together and the L92 starter fit perfectly. It slid inside the bellhousing just fine and appears to be aligned just fine.

I'll try and post pics and get your thoughts.

jmd

iTrader: (4)

Excellent.

I knew The F-body bell & starter can't be mixed with GTO bell & starter. I wasn't sure about differences on the truck one. Good thing to know.

DRTHVDR

iTrader: (6)

Hey.....who thought putting an L92 into an RX-7 would yield new info into the LSX community?!

Since it fits....do you think I need to worry about any other spacing? The teeth should all line up correct, right?

jmd

iTrader: (4)

Yep. Same ring gear teeth across the board on LS motors.

DRTHVDR

iTrader: (6)

Great...So the ONLY Issue is the Housing fitment with the size of the starter.

OK WORLD: L92 Starters work with T-56 F-Body transmissions!

DRTHVDR

iTrader: (6)

Here are the pictures after everything went together.

DRTHVDR

iTrader: (6)

*Double post*