T&T on the New 402... Video included
07-30-2010, 07:08 PM
#1
11 Second Club
Thread Starter
iTrader: (12)
Join Date: Sep 2003
Location: Monroe Wa.
Posts: 1,389
Likes: 0
Received 0 Likes
on
0 Posts
T&T on the New 402... Video included Finally got to the track to do some Shakedown runs on the new 402 Iron Block. 1st run was a respectable 11.17@121mph, 1.62 60 ft. Unfortunately as the night went on my times got slower as we realized I was losing 3rd gear Clutches.. Good thing was, I got my 60ft times down to 1.57. We will be yanking the Trans in the next few weeks and freshening it up. Hopefully we'll get her out to the track again before the nice weather leaves!!!!
http://www.youtube.com/watch?v=xRnWo18ribQ
http://www.youtube.com/watch?v=n8k3R6ZaBxM
http://www.youtube.com/watch?v=xRnWo18ribQ
http://www.youtube.com/watch?v=n8k3R6ZaBxM
08-03-2010, 07:24 PM
#4
11 Second Club
Thread Starter
iTrader: (12)
Join Date: Sep 2003
Location: Monroe Wa.
Posts: 1,389
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys. Nothing like 11.5 to 1 Comp. to get things spinning..
Took it to the Dyno on Sat, Put down 461 to the Wheels.
Reved her to 7000rpm and she barely dipped in power. Should be very interesting when we get the Plate kit installed!!!!
Took it to the Dyno on Sat, Put down 461 to the Wheels. Reved her to 7000rpm and she barely dipped in power. Should be very interesting when we get the Plate kit installed!!!!