98RedBird

iTrader: (77)

I have to head to the exhaust shop tomorrow to get a pipe made for my duals. Problem is I don't have a piece of pipe that I can fit on the drivers side to extend past the O2 sensors. I know that running open headers can be tough on the O2 sensors and the trip is about 30 miles. Will it hurt to run it out there open headers with no extensions off the collectors?

Jon@Texas-Speed

iTrader: (18)

Nah it will be fine. It might get a little air back across the sensors and add some fuel but it shouldn't hurt it for a quick trip to the exhaust shop.

Jon

omarrakeen

iTrader: (2)

it would hurt nothing, i drove mine with no problems.

Duffster

iTrader: (103)

yeah, what Jon says. . . just careful letting off the gas, it'll backfire a lot then.

98RedBird

iTrader: (77)

Sounds good. Thanks guys.

Steve Gunn

Might want to wait for a shift change at the local PD. I did this once and **** myself the whole way there.

awake1630

i thought your exhaust was done and all set up

98RedBird

iTrader: (77)

^^^ It was. I put Spohn Solid mounts in and it raised the motor a little, so now I have to get a pipe tweaked...

KRAZY K 2000 TA

iTrader: (5)

i had one whole township thinking it was drag week!! Loved my 402 RIP

LilJayV10

iTrader: (39)

I tried it. Fouled my plugs out within 10 miles. I ended up flat bedding it to the exhaust shop which is across town. The O2's see the fresh air and dumps fuel in because it thinks its running lean.