Black_Z28

iTrader: (1)

Where is the best place to buy supplies to make a custom intake inlet? Right now I have one, and it's make out of mild steel, so it's starting to rust on the inside of the pipe, and I'm worried about it flaking and being sucked into my blower. I would like to make it out of 304SS, but I could go aluminized steel as well. It doesn't need to be too long, just a straight section, to a 90* elbow, then down again. Also, it's a 3.5" inlet.

408trans_am

iTrader: (263)

I get all of my tubing and fabrication material from Colombia mandrel bending, if you are looking for something larger like 4" to 6" then verocios motorsports and race parts solutions is the place to go. All of them will have the material at your door in 2 to 3 days. these are what most builders on here get their material from.

www.mandrelbends.com
www.verociousmotorsports.com
www.racepartsolutions.com

Engine_HP

iTrader: (1)

http://store.airflo.com/

http://www.intakehoses.com

i tried both of them, no complaints.

defaultexistence

iTrader: (11)

eBay.....why dont people know you can get ANYTHING on ebay by now.....
example...http://cgi.ebay.com/ebaymotors/UNIVE...item41526f13f5