LS1TECH - Camaro and Firebird Forum Discussion

Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories
Sponsored by:
Sponsored by:

TO low??

   
Old 01-29-2004, 04:18 PM
  #1  
Teching In
Thread Starter
iTrader: (2)
 
White94Z's Avatar
 
Join Date: Jan 2002
Location: Kansas
Posts: 22
Likes: 0
Received 0 Likes on 0 Posts

Default TO low??
I recently purchased Hooker LT's, and i have plans on lowering the Car (01 SS) would sportlines take the car to low where i would have problems with scraping the Ypipe often?

thanks
White94Z is offline  
Reply Like
Old 01-29-2004, 04:41 PM
  #2  
TECH Fanatic
 
SSactionLs1's Avatar
 
Join Date: Oct 2002
Location: nor cal (ripon)
Posts: 1,255
Likes: 0
Received 0 Likes on 0 Posts
Default
Originally Posted by White94Z
I recently purchased Hooker LT's, and i have plans on lowering the Car (01 SS) would sportlines take the car to low where i would have problems with scraping the Ypipe often?

thanks
will be close. I have prokit and my pacesetters have about 2.5" clearance. (well the clamps do)..if you weld everything i doubt youd have any problems
SSactionLs1 is offline  
Reply Like
Old 01-29-2004, 07:41 PM
  #3  
jrp
SN95 Director
iTrader: (16)
 
jrp's Avatar
 
Join Date: Jul 2003
Location: Valencia, Ca
Posts: 10,755
Likes: 0
Received 4 Likes on 4 Posts

Default
get a custom Y, that way you have the best clearance possible.
jrp is offline  
Reply Like
Old 01-30-2004, 08:03 PM
  #4  
10 Second Club
iTrader: (1)
 
1BADAIR's Avatar
 
Join Date: Jan 2003
Location: oxford, Michigan
Posts: 1,902
Likes: 0
Received 1 Like on 1 Post

Default
I have Jet hot's and a hooker Y with a prokit. I have more room now than with my SLP Y and loud mouth.
1BADAIR is offline  
Reply Like
Back to Subforum
Generation III External Engine
View Next Unread
Surface rust on coated pacesetters????


Thread Tools
Search this Thread
Search this Thread:

Advanced Search

Advanced Search

All times are GMT -5. The time now is 09:31 AM.