PCM Diagnostics & Tuning HP Tuners | Holley | Diablo
Sponsored by:
Sponsored by:

Weird LTFT

Thread Tools
 
Search this Thread
 
Old 01-29-2004, 09:19 PM
  #1  
11 Second Club
Thread Starter
iTrader: (2)
 
Ed Blown Vert's Avatar
 
Join Date: Nov 2001
Location: Sunny San Diego
Posts: 3,066
Likes: 0
Received 0 Likes on 0 Posts

Default Weird LTFT

Even since I re-installed my cats. I have been getting the over rich codes.

My LTFT's on bank 1 with shoot up well over +20 if I give it some gas. Then go down to normal.

I swapped O2 sensors, even disconnected it on the driver side.

And it still shoots up.

Any ideas??
Old 01-29-2004, 09:20 PM
  #2  
TECH Senior Member
iTrader: (33)
 
WS6FirebirdTA00's Avatar
 
Join Date: Mar 2003
Location: North Carolina
Posts: 8,318
Likes: 0
Received 1 Like on 1 Post

Default

what about at steady throttle? when was the last tune put in the car?
Old 01-29-2004, 09:38 PM
  #3  
11 Second Club
Thread Starter
iTrader: (2)
 
Ed Blown Vert's Avatar
 
Join Date: Nov 2001
Location: Sunny San Diego
Posts: 3,066
Likes: 0
Received 0 Likes on 0 Posts

Default

Cruising, Bank 1 stays above 0. Right around 3-7. Eventually it will drop below 0, like bank 2.

I think it started after I uploaded a tune. Not really sure, that was about the time my tranny started to slip.

I have thrown p0172's and p0175's
Old 01-29-2004, 09:50 PM
  #4  
TECH Senior Member
iTrader: (33)
 
WS6FirebirdTA00's Avatar
 
Join Date: Mar 2003
Location: North Carolina
Posts: 8,318
Likes: 0
Received 1 Like on 1 Post

Default

after my new tunes are put in the computer my STFT's go to crazy numbers. give it some time and see how it is. as long as your part throttle is ok and at 0 i wouldnt be too worried for the time being, drive the car some more and see if it changes
Old 01-29-2004, 09:56 PM
  #5  
11 Second Club
Thread Starter
iTrader: (2)
 
Ed Blown Vert's Avatar
 
Join Date: Nov 2001
Location: Sunny San Diego
Posts: 3,066
Likes: 0
Received 0 Likes on 0 Posts

Default

The tune I uploaded was for Transmission shifts. I took care of my LTFT's a while back.

I guess re-installing the cats could get things out of whack. I put them back in Sun.

It's just weird because they are only happening on one-side.
Even when Bank 1 finally drops below 0, just a touch of the throttle and they will jump up way past zero.
Old 01-29-2004, 09:59 PM
  #6  
TECH Senior Member
iTrader: (33)
 
WS6FirebirdTA00's Avatar
 
Join Date: Mar 2003
Location: North Carolina
Posts: 8,318
Likes: 0
Received 1 Like on 1 Post

Default

well if i change my cooling fans it takes a while for fuel trims to get workin again. i would give it time since u just put the cats back on and then let us know
Old 01-29-2004, 10:25 PM
  #7  
11 Second Club
Thread Starter
iTrader: (2)
 
Ed Blown Vert's Avatar
 
Join Date: Nov 2001
Location: Sunny San Diego
Posts: 3,066
Likes: 0
Received 0 Likes on 0 Posts

Default

Cool, thanks.
Old 02-02-2004, 03:21 AM
  #8  
TECH Apprentice
 
finalymodded's Avatar
 
Join Date: Jul 2002
Location: MS.
Posts: 318
Likes: 0
Received 0 Likes on 0 Posts
Default

watch which cells are showing rich. you may need to give some tuning attention to those particular cells.
Old 02-02-2004, 05:18 PM
  #9  
11 Second Club
Thread Starter
iTrader: (2)
 
Ed Blown Vert's Avatar
 
Join Date: Nov 2001
Location: Sunny San Diego
Posts: 3,066
Likes: 0
Received 0 Likes on 0 Posts

Default

Never watched cells. Can you with EFI?




All times are GMT -5. The time now is 08:11 PM.