3500lt
12-06-2010, 02:29 PM
still trying to figure out my plan for my master powerplant. Im almost finished installing my 9inch fab rear with all the goodies and figured its a good time to start getting a parts list together for my cold weather project. I want a good street/strip motor with 427CI. Im thinking a Sleeved ls2 block with a 4.125 bore. I am thinking of using a decent callies 4in stroker kit with forged pistons to run 11.5.1 with p/p L92 heads.
I am trying to figure out which cam to go with. I might buy two and try them both out. Im looking for max power with maximum streetability. It needs to run on pump gas.
I am planning on running at least a 90mm intake and throttlebody.
just looking for advice on fuel delivery, with pump and injector sizes and a good cam/valvetrain idea. I dont want to go over 6k-6800 rpms.
Im looking for 580-600whp through a t-56 and a 9" with 3.89 gears. vroom vroom.
Thanks for any advice. Ill pay the community back with a nice video when the bird is all buttoned up this spring.
I am trying to figure out which cam to go with. I might buy two and try them both out. Im looking for max power with maximum streetability. It needs to run on pump gas.
I am planning on running at least a 90mm intake and throttlebody.
just looking for advice on fuel delivery, with pump and injector sizes and a good cam/valvetrain idea. I dont want to go over 6k-6800 rpms.
Im looking for 580-600whp through a t-56 and a 9" with 3.89 gears. vroom vroom.
Thanks for any advice. Ill pay the community back with a nice video when the bird is all buttoned up this spring.