Found
#1
Teching In
Thread Starter
iTrader: (5)
Join Date: Apr 2010
Location: NEArkansas
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Found
Looking for both of these and have money in hand. I want a good block that needs no machine work, just a light hone at the most and put it together. I might take one that needs a little main work done but nothing as far as cylinder boring goes. Preferably not all the way across the country, as I'm not looking to spend a fortune. Also need an LS2 or LQ9 crankshaft, would take one that needs to be turned for the right price but a nice used one would be better. Need only those as I'm looking to mate it with a stock set of LS2 rods/pistons without any balancing work.
Thanks
Thanks
Last edited by bo.benson; 02-23-2011 at 07:35 AM.
#4
Banned
iTrader: (20)
Join Date: Apr 2009
Location: Inside Your Girlfriend
Posts: 1,120
Likes: 0
Received 0 Likes
on
0 Posts
I have a Pre-04 LQ4 with less than 25K; I got it to build a 415 stroker, but went a different rout. I was told that one Cyl has a spun rod bearing, but outside of that it's good. It dirty as hell, lol, but a good foundation.
Block, Pistons, Rods, Crank
I paid $700 for it, but asking $500+ shipping/handling and paypal
DM
Block, Pistons, Rods, Crank
I paid $700 for it, but asking $500+ shipping/handling and paypal
DM
#5
Teching In
Thread Starter
iTrader: (5)
Join Date: Apr 2010
Location: NEArkansas
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Looks like I'm back to needing a block, bought a local one with a little rust in the cylinders. Honed it out today and has a gouge in #2, gonna have to be bored which= No good to me.