quik95lt1

iTrader: (7)

Ok this is an odd one.....wondering if anybody else has seen this.......


i noticed that my cometic gaskets are partially covering the oil return holes at the front and rear of my trick flow cylinder heads.......has anybody else seen this???

i think i may modifiy the gasket to allow the oil to pass......

gregrob

iTrader: (8)

Hmmm.. im gonna be using them too, ill have to pay close attention.

Wicked94Z

iTrader: (26)

time to pull it back apart i run mr gasket mls... never noticed this issue on mine

quik95lt1

iTrader: (7)

nope i made a tool lol.......gonna open em up with out drilling and do it with the head on........watch this creation I'll post up pics tomorrow night lol

quik95lt1

iTrader: (7)

that may have been my oil drain back issue before though.......i never noticed it before and my old head gaskets are the same.......i prob had this issue from day one

jay7199

iTrader: (9)

do you have the new trickflows?? i need to look into this myself.

quik95lt1

iTrader: (7)

no they're the old 23* heads....

355z28

iTrader: (8)

Yeah "old" with an "out of date port job right

Just messing with you. Actually been talking to phil I noticed felpro has a couple gaskets with the same design you ran into. Im not sure why they do this.

robsquikz28

iTrader: (246)

lets see the fancy tool

litch2004

iTrader: (1)

My victor reinz were the same way on my factory heads

flyinZ

iTrader: (15)

Id ask Phil/Ron, and see what they say. Maybe they have ran into this before and have a remedy. I dont remember, the last time I had my setup apart.