Guys who have the Ram 10.5 twin disc setup installed look here
03-14-2011, 04:57 PM
#1
On The Tree
Thread Starter
iTrader: (3)
Join Date: Apr 2005
Location: Plainfield, IN
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Guys who have the Ram 10.5 twin disc setup installed look here Did you have to use a shim with your setup or not??
I have done several reworded searches and had no luck finding anything..
I will have this apart this week and want to have a few shims in hand when we do it rather than tear it apart, measure, then wait on parts.
Thx
I have done several reworded searches and had no luck finding anything..
I will have this apart this week and want to have a few shims in hand when we do it rather than tear it apart, measure, then wait on parts.
Thx
03-15-2011, 01:57 PM
#2
The last we installed here did NOT need a shim, but as you already know you want to be prepared to measure and be sure!
__________________
Largest Stocking Distributor of LS-x Engines / CHECK OUT OUR NEW WEBSITE!
COMP - FAST - PACESETTER - DIAMOND RACING - EAGLE SPECIALTY PRODUCTS - CALLIES - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - KOOK'S HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - AND MORE!
Largest Stocking Distributor of LS-x Engines / CHECK OUT OUR NEW WEBSITE!
COMP - FAST - PACESETTER - DIAMOND RACING - EAGLE SPECIALTY PRODUCTS - CALLIES - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - KOOK'S HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - AND MORE!
