Location for Trans temp Sender?
#1
Banned
Thread Starter
iTrader: (4)
Join Date: Jul 2010
Location: Texas
Posts: 352
Likes: 0
Received 0 Likes
on
0 Posts
Location for Trans temp Sender?
I would like to install the sender for my auto meter gauge into the actual cooler line leaving the trans, like some sort of actual adapter fitting for 1/4npt that is actually about a inch deep to screw the sendering into? any help
worst case i can tap it into the pan.
worst case i can tap it into the pan.
#2
I used one on-line on my Jeep. Brass t fitting with compression fittings. I just took the sending unit, electronic, in to napa and got what I needed. Mine seems to always have a small drip though no matter what. I went with one in the pan for my Firebird though. Much better in my opinion.
#3
TECH Senior Member
iTrader: (96)
Join Date: Aug 2007
Location: Turnin' Wrenches Infractions: 005
Posts: 24,241
Likes: 0
Received 79 Likes
on
70 Posts
Reading temps going through the cooler lines is a waste IMO. The pan gives you the best average temp of the fluid. And you cant tap the stock pan. You'd have to have an after-market aluminum one for that.