Need input on stock pulley mod
#1
Need input on stock pulley mod. Pic inside
This is a picture of a stock corvette pulley/balancer with the AC (rear) section cut away on a lathe. It is substantially lighter now, but the concern we have is whether or not removing this area will have an adverse effect on the dampening.
This is just an experiment, so please just state your input on the question at hand and don't reply w/ "just buy an underdrive pulley dumbass!!"
Thanks,
Al and Brandon
This is just an experiment, so please just state your input on the question at hand and don't reply w/ "just buy an underdrive pulley dumbass!!"
Thanks,
Al and Brandon
Last edited by Dead Hooker; 02-20-2004 at 10:36 PM.
#3
UNDER PRESSURE MOD
iTrader: (19)
Yeah.... I'd be pretty concerned about putting it back on the front of the crank after you have cut off part of it. Who knows what the balance is right now. You might be doing more harm than good by doing that.
That's just my oppinion, but think carefully before installing it.
That's just my oppinion, but think carefully before installing it.