06colorado

iTrader: (4)

I have a 99 iron head 6.0 that I was hoping to use. Is it capable to bolt a th400 behind this or would i need to swap cranks. Iv had a few people tell me there is problems with these. Thanks

forcd ind

iTrader: (7)

does it have a flywheel on it? how much does the crank stick out past the rear seal-if aprx. 3/8" past the seal, it has the longer rear crank section, just use a stock 4l80e flywheel and your good to go
pics would help, cause the crank could have been changed at some time

06colorado

iTrader: (4)

Yes the flexplate is still on. I'll take some pics with measurements this evening when I get home thanks for the help

06colorado

iTrader: (4)

Sorry didnt get to take pictures yet. Camara is out of commission right now lol

I did measure the distance between seal and were the flexplate starts and it is right at 3/8. So is should be good if i use the stock flexplate right?

forcd ind

iTrader: (7)

is the stock FW flat, not curved

06colorado

iTrader: (4)

I just went out and looked at the FW. It is staight and only has little raised spots were the converter bolts up. I will get another camara either tonight or tomorrow and take some pics. I really appreciate the help Forcd Ind