User Support & Resources - Sig Help Needed

I have posted this in the Sig Testing and Design section, but thought I could find an answer here too. I am trying to enter my restoration thread into my sig. I have seen some poeple who did the same. However, my sig only shows the "URL", and not the thread title.

Is there a way I can do this, or can a moderator do it for me so that the actual thread tile is displayed in the sig, rather than the URL like it is now?

Thanks.

I fixed your signature. Go to your Signature in your UserCP if you want to see how it was done.

Basically:

Title you want to assign to link goes here (URL/Address Goes Here)

I fixed your signature. Go to your Signature in your UserCP if you want to see how it was done.

Basically:

Title you want to assign to link goes here (URL/Address Goes Here)

Thank you very much! I tried messing with it a few different ways and never got it right. I will remember this for the future though. Thanks again!

......