Evilution

i have the fast 1375 cfm 4150 tb and the victor jr. intake. what throttle bracket do i use? also so i need a new throttle cable? any other odds and ends i may need for the install? just wanna make sure i have all the parts needed. and yes i will be getting a SD tune.

tb part number is FAST 307603

98SSClone

iTrader: (2)

The 86-93 S10 4.3 TBI throttle cable should work... not sure about the bracket.

BADD SS

iTrader: (4)

I ordered a regular anodized aluminium one for a carb that was red, and modified it for the stock cable. Dont get a lokar cable whatever you do, they friggen suck.

nastychevelle

iTrader: (7)

i used a regular carb style bracket with a 89 blazer throttle cable on my Accell 4150 TB setup.
Kind of a bad picture (wasnt finished with everything)

Dmoney

iTrader: (22)

This is what I ordered:
Part #

29086 Vic Jr. w/ fuel rails
TC1000636 Lokar cable(cut to fit)
15152 Jegs throttle cable bracket
M592438 intake gaskets for Vic jr.
RGR501 fuel rail kit from Speed Inc.
9749 (2) 45* elbows
9849 Spectre carb hat

Take your Map sensor off you intake and the Victor Jr. will come with a bracket to mount the MAP sensor to the back bolt on top of the intake before you bolt on the throttle body and you just run a hose from the sensor to the intake...........

subhumanzz

iTrader: (46)

4.3l blazer cable?

Mike Blanco

I need to get a pedal and Throttle cable for this super vic setup. I was planning on getting a Lokar pedal and their throttle cable. However, not sure if I will now. I spoke to them this morning and they did not have a brake for the cable mounting to the motor. Any ideas on a pedal and cable recommendation?

slowsol95

iTrader: (1)

Im using a regular oem throttle cable and using a lokar cable end to adapt it to the 4150 throttle body. This was the cheapest option if you already have the correct gen gm cable.

Mike Blanco

Right now I do not have anything. I need a pedel, cable, and I think there is some bracket that I need that will bolt to the motor. Also my throttle arm on the 4150 is striking the underside of the air filter. I guess once I get it outfitted I can just cut the top of the arm on the 4150 to clear the air filter?

I am just trying to figure out how I need to set this up and the parts I need. This is my first setup. All help is appreciated.